Penis Pump Max Boost Blue 19.1 x 8.3 cm

Penis Pump Max Boost Blue 19.1 x 8.3 cm 💙

The Penis Pump Max Boost by Pump Worx is a piston pump that works without any hose, handle or pump bulb. You create the vacuum with the dark blue cap at the top, which works like a piston. Below the cap comes a copper-coloured ring with a round button in it. The clear cylinder carries two printed scales with the “Max Boost” lettering between them. At the lower end sits a soft dark blue silicone sleeve with a round opening. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Worx.

✨ At a glance

• ✅ Type: penis pump with piston action
• 🧵 Material: silicone and ABS
• 🎨 Colour: blue
• 📏 Dimensions: 19.1 x 8.3 cm
• ✅ Pump: cap as piston, no hose
• ✅ Sleeve: silicone, removable
• 📐 Cylinder: clear, two scales
• ⚠️ Caution: only a few minutes at a time

❓ FAQ

How do you pump without a hose?

With the cap. You press it down and move it back up; each stroke takes a little air out of the cylinder. Because nothing hangs on a hose, you hold the whole pump in one hand.

How do you release the vacuum?

Via the release valve. The air flows back in and the cylinder comes away from the body without pulling. Try this once without body contact before you put the pump on for the first time.

What do you watch out for when pumping?

A calm build-up and short sessions. Work with slow strokes and hold the suction for only a few minutes at a time. If you feel pain or numbness, or notice discolouration or blisters, release it at once. The testicles stay outside the cylinder, you do not pump on injured skin, and the scales are only a guide.

How does the silicone sleeve seal?

It lies softly against the skin. Place the cylinder on straight so that it touches all the way round; short hair helps. A drop of water-based lubricant improves the seal and suits silicone, and you will find suitable ones under water-based lubricant.

How do you clean the pump?

Take the sleeve off and wash it separately. It gets warm water and mild soap, and so does the cylinder. Only wipe the cap with the piston with a damp cloth; afterwards everything dries in the open air.