Penis Pump RX9 with Sleeve Black 30 x 6 cm

Penis Pump RX9 with Sleeve Black 30 x 6 cm ⚫

The Penis Pump RX9 with Sleeve by Pump Addicted consists of the Power Pump RX-9 and a Pleasure Sleeve in size M. The pump has a black-tinted cylinder with a scale and a flat head on which a round pressure gauge sits. From the head the hose runs to the grip handle, and at the bottom a wide black ring closes off the opening. The sleeve is made of soft, translucent TPE: a channel with nubs and ribs, a wide collar and an opening shaped like a vulva. Once inserted, it turns the device into a masturbator. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of Pump Addicted.

✨ At a glance

• ✅ Type: penis pump with masturbator sleeve
• 🧵 Material: ABS and TPE
• 🎨 Colour: black
• 📏 Dimensions: 30 x 6 cm
• ✅ Display: gauge on the head
• ✅ Pump: grip handle on the hose
• ✅ Sleeve: Pleasure Sleeve, size M
• ⚠️ Caution: hold the suction only briefly

❓ FAQ

How do you fit the sleeve?

Channel inwards, collar to the front. The narrow part slides into the cylinder, and the vulva opening stays at its rim. When you pump, the vacuum lays the soft inner wall around the shaft. Without the pump the sleeve can be used as a hand masturbator.

What does the gauge show you?

The current vacuum in the cylinder. The needle shows you how much each stroke does, so you can increase carefully. It is only a guide, not a target for a particular value.

What do you watch out for when pumping?

Start calmly and pause early. Hold the suction for only a few minutes at a time. Pain, numbness, discolouration or blisters mean: let the air out at once. Make sure the testicles do not get into the cylinder, and never pump on injured skin.

Which lubricant do you use?

A water-based one. It suits the TPE of the sleeve and improves the seal at the ring. You will find suitable gels under water-based lubricant.

How do you clean the sleeve and the cylinder?

Both with warm water. Rinse the channel of the sleeve thoroughly and let it dry completely. For the cylinder you also use mild soap and keep the gauge dry.