Penis Pump Size Matters Pump Kit with a Gauge Acrylic Clear 26 cm

Penis Pump Size Matters Pump Kit with a Gauge Acrylic Clear 26 cm 📈

The Size Matters Pump Kit penis pump by XR Brands is a set of an acrylic cylinder, a hose and a hand pump with a gauge. The clear cylinder carries a scale along its whole length and ends at the bottom in a wide rim. At the top sits a valve that holds the vacuum when the hose is pulled off; the cylinder then stays on by itself and your hands are free. The pump has a silver pump body with a round gauge and two black handles that you squeeze together, plus a valve for releasing. It stands under pumps, with sex toys for men and under sex toys; what else comes from this brand is shown by the brand world of XR Brands.

✨ At a glance

• 🧵 Material: acrylic and silicone
• 📏 Length: 26 cm
• ⭕ Cylinder width: 2 inches (about 5.1 cm)
• 🎨 Colour: clear
• ✅ Display: scale on the cylinder and gauge
• 🎛️ Operation: hand pump with two handles
• ✅ Valve: holds the vacuum without the hose
• 🪜 Range: Size Matters
• ⚠️ Caution: build the vacuum slowly and hold it for a few minutes only

❓ FAQ

How is the cylinder put in place?

With lubricant on the rim. A little water-based lubricant on the wide rim makes the cylinder sit tightly against the body; without a seal no vacuum builds. Matching products can be found under water-based lubricant.

What do you watch for when pumping?

Build it slowly, hold it briefly. The vacuum rises step by step and stays for a few minutes only. At pain, numbness, discolouration or blisters you release the air at once. The testicles do not go into the cylinder, and there is no pumping on injured or irritated skin.

What are the scale and gauge for?

For orientation. The gauge shows the vacuum, the scale on the cylinder the length. Both help to repeat a routine that felt good next time; there is no limit that suits everyone.

How is the set cleaned?

Rinse the cylinder, wipe the pump. Wash the cylinder and rim with warm water and mild soap and let them air-dry. Clean the pump body, gauge and handles only with a damp cloth, and let the hose dry completely before storing.