Penis Sleeve Ohmama for Penis and Testicles Smoke Grey 14 x 3.2 cm

Penis Sleeve Ohmama for Penis and Testicles Smoke Grey 14 x 3.2 cm ⚡

The penis sleeve by Ohmama in smoke grey takes the penis and testicles at the same time. The penis part is ribbed on the outside and ends at the front in a closed, darker tip. Below it sits a broad part that encloses the testicles. Three small motors sit at the tip, at the top of the base and at the bottom of the testicle part. The two motors at the base and on the testicle part sit visibly on the outside in round, dark holders. It stands under penile enlargement, with sex toys for men and under sex toys for couples; what else comes from this brand is shown by the brand world of Ohmama.

✨ At a glance

• 🧵 Material: silicone
• 🎨 Colour: Smoke grey
• 📏 Length: 14 cm
• ⭕ Diameter: 3.2 cm
• 🛠️ Design: penis part with testicle part
• 📳 Power: three motors

❓ FAQ

How do you put it on?

Put a little water-based lubricant into the sleeve, guide the penis into the upper part and lay the testicles into the lower one. It is easiest while the penis is not yet fully erect. You will find suitable lubricant under water-based lubricant.

Why does the cock ring rule apply here?

Because the sleeve also encloses the testicles and sits there like a ring. Wear it for no more than 20 to 30 minutes at a time, take it off at once if there is numbness, cold, discolouration or pain, and never fall asleep with it on. With blood thinners, only use it after consulting a doctor.

Does it replace a condom?

No, it is neither a condom nor protection against infections. You will find condoms under condoms.

What does your partner get from it?

The ribs of the penis part and the tip with its motor lie on the outside; both are meant for your partner. Start slowly and talk about what feels good.

How do you clean it?

With warm water and mild soap or a cleaner from sex toy cleaner, inside and out. Do not submerge the parts with the motors; afterwards the sleeve dries completely in the air.

How do you store it?

Dry and on its own, ideally in a pouch so that no dust gets onto the surface. Before you put it away, the motor holders should be completely dry as well.