Pump Insert Bathmate for Hydromax 9

Pump Insert Bathmate for Hydromax 9 🔧

An insert that reduces the opening of the cylinder. It sits at the bottom of the cylinder and makes sure the pump seals cleanly even when the girth does not fill the full width. Without a seal a hydro pump builds no vacuum, and that is exactly what this part is for. It stands with the accessories, with pumps and in the Markenwelt von Bathmate.

✨ At a glance

• ✅ Manufacturer: Bathmate
• 🧵 Material: plastic
• 🎨 Colour: White
• 🔩 Design: insert for the cylinder base
• 🎯 Use: Hydromax 9, improves the seal

❓ FAQ

When do you need an insert?

When the pump matches the right length but the cylinder is too wide at the base. It then pulls air instead of water and the vacuum keeps collapsing. The insert reduces the opening without a different pump being necessary.

How do you notice something is not sealing?

The pump cannot be pressed empty, water runs back at the rim, or the suction holds for seconds only. Usually it is the seal at the bottom and not the device.

Does it fit other pumps as well?

No, it is cut for the Bathmate cylinders. A part that does not fit perfectly costs exactly the seal it is there for, so accessories from other ranges do not pay off here.

How is it cleaned?

Rinse it with warm water and let it dry openly before it goes back on the pump. Moisture that stays trapped is the only way a part like this goes bad.